Standard Electrode Holders
The electrodes are produced, used and stocked at these extremely reasonable electrode holders, made of aluminium and provided with galvanic surface protection. The holder can also be used on wire EDM because of chromating of the surface.

For electrode machining, the holders are held on the clampers shown from page 8 to 10.

These six standard electrode holders are supplied without clamping journal.

Repetitive accuracy in the tool clamper 0.002 mm (0.00008")

H 5.49 A Pallet
For copper electrodes up to Ø ˆ 75 mm (2.952"), for graphite electrodes up to Ø ˆ 100 mm (3.937"), milled on H 8.811..For fastening of electrode blanks by screwed connection from above or below.
Without clamping bores.
Delivery quantity: 9 pieces without clamping journal.
Weight: 0.12 kg (0.265 lbs)

H 5.49/70 A Pallet for self-machining
Same design as for H 5.49 A, but 70 mm (2.755") long. Delivery quantity: 9 pieces without clamping journal. Weight: 0.25 kg (0.551 lbs)

H 8.88 A Pallet
For copper electrodes up to Ø ˆ 100 mm (3.937"), for graphite electrodes up to Ø ˆ  150 mm (5.905"), milled on H 8.811. Otherwise same design as for H 5.49 A.

Delivery quantity: 5 pieces without clamping journal. Weight: 0.5 kg (1.10 lbs)

H 8.128 A Pallet
For copper electrodes up to Ø ˆ 160 mm (6.299"), for graphite electrodes up to Ø ˆ 250 mm (9.841"), milled on H 8.811.1.

Delivery quantity: 1 or 5 pieces without clamping journal. Weight: 0.5 kg (1.10 lbs)

H 5.50.25 A Holder
Aluminium Vee block holder, chromalized, for the fixturing of electrode blanks of 15 x 15 to 25 x 25 mm (0.59" x 0.59" to 0.984" x 0.984") or Ø 15 to Ø 25 mm (0.59" to 0.984"). Delivery quantity: 9 pieces without clamping journal. Weight: 0.15 kg (0.33 lbs)

H 5.50.3 A Holder
Aluminium flat holder, chromalized, for the fixturing of flat electrode blanks up to 20 mm (0.787") thickness.

Delivery quantity: 9 pieces without clamping journal. Weight: 0.15 kg (0.33 lbs)

H 5.611 Clamping Journal with
H 5.611.1 Centering Bush
All electrode holders (except the holders and pallets on page 17 and the pallets on page 18) are provided with Clamping Journal H 5.611, (with boring for central flushing) and the Centering Bush H 5.611.1.
With this combination of clamping journals, all pallets and holders fit into the magazine forks shown on page 26 and into other forks.
The Centering Bush H 5.611.1 can be replaced by the Distance Sleeve H 5.611.2 for deposition in the older Magazine Forks H 5.57...