Manual
Tool Clamper
With cam-controlled
quick clamping and central flushing
Pneumatic Tool
Clamper
With spring loaded, normally closed piston system, opened by
compressed air.
Running and
repetitive accuracy
|
HIRSCHMANN
Fixturing and Handling Systems
·
- high precision and
versatility for electrode weights
up to 100 kg/220.5 lbs (400 kg/882
lbs)
-
solid and not
susceptible to shocks
-
constant accuracy
-
positive
connection of the tool plane
-
0.002 mm
(0.00008") repetitive accuracy and consistency
-
Internal and
external flushing built in for defined
flushing direction
-
rust-proofed
-
not affected by
dirt
-
not affected by
heat. The center will be kept, even in case of an extreme temperature rise
(cross hair centering)
-
Compatible with
the Fixturing Systems 2000 and 4000.
Operation
Most tools are supplied together with
an operating manual. Correct operation cannot be ensured and danger to personnel
and machine cannot be excluded unless these operating instructions or
information given in this catalogue are observed.
Precision
The individual tool planes incorporate
hardened and artificially aged precision ground centering Vee blocks and
separate Z-supports. This assures position centering of each tool. When the
reference points are in alignment, a repetitive accuracy (consistency) of <
0.002 mm (0.00008") is achieved, measured 100 mm (3.937") below the
tool plane.
When
indexing an electrode holder in the Vee block by 4 x 900, the axis position will
be < 0.004 mm. It must be remembered here that the axis displacement of the
electrode holder, for example of a collet holder, and of the collet will add to
the axis position variation.
Cleaning and
lubrication
The tools should be cleaned with a
clean cloth, on no account with compressed air. Only oil must be used for
lubrication.
Technical
modifications
As all products shown in this
catalogue are subject to continuous further developments, we reserve the right
for technical modifications.
Quality
according to DIN EN ISO 9001
All HIRSCHMANN GMBH products
are produced using the latest production methods, and are subject to quality
assurance measures as per DIN EN ISO 9001 both during production and in the
product stage.
Warranty
We provide a 12-months warranty for
all fixturing system parts produced by us, starting from the invoice date, and
assuming correct use and maintenance as specified.
The
warranty is restricted to replacement or repair, free of charge, of any
defective parts. Claims going beyond that shall not be considered.
Warranty
claims shall be submitted without delay and in writing.
|
